Balloon Chat
Uncategorized Boards => Model Of The Month => Topic started by: Graham Lee on February 28, 2019, 04:56:19 PM
We are going with the Duck design for the model of the month.
Included in every order we send out will be the complimentary
pack of balloons so you can make the design.
Inflate the yellow 260 and leave approx. 5 fingers un-inflated.
Make a 4 finger fold twist for the head, then a 2 finger bubble and a 2 finger pinch twist.
Then for the body a 5 finger bubble followed by a 1.5 finger pinch twist.
The tail is a 3 finger fold twist.
Then make another 5 finger bubble back to the front pinch twist.
Followed by another 5 finger bubble back to the tail pinch twist.
The remainder of the balloon wrap very tightly around the lower
5 finger body bubble and tie into the rear pinch twist.
Discard the rest of the balloon.
Position the neck bubble between the two 5 finger upper body bubbles.
Inflate the orange 160 to approx. half way, you can get two beaks from the one balloon.
Make a 4 finger fold twist.
Then make two 4 finger bubbles and make these into fold twists for side of beak.
Attack to the head of duck.
Make a 4 finger bubble in a white 260.
Split into two 2 finger bubbles for the eyes.
Push into the head and add artwork.
You can add the blue 260 around the lower section of duck and add to a hat
or just have the duck on the blue 260 as a display.
If you do make then please post a picture or two, thanks.
Went for the hat option.did I attach it correctly?