Balloon Chat

Uncategorized Boards => Picture Gallery => Topic started by: Graham Lee on May 30, 2018, 05:07:39 PM

Title: Gumball Machine
Post by: Graham Lee on May 30, 2018, 05:07:39 PM
I started to make the gumball machine today but with orders coming
and going and emails etc we have not as yet had time to finish it.
Title: Re: Gumball Machine
Post by: Graham Lee on May 30, 2018, 05:08:50 PM
I will balloon shine the clear so fingers crossed it comes up looking non foggy.
Title: Re: Gumball Machine
Post by: Graham Lee on May 31, 2018, 09:10:19 AM
I did not like the look of the joint form the weaved red base to the
clear balloon so added a 160 red. Plus the feet of the base the centre
was lower than the outer rubber stoppers so I put a 260 chrome
below the centre so the feet splayed downwards. Hoping to take some
nicer pictures this morning of the design.
Title: Re: Gumball Machine
Post by: Graham Lee on May 31, 2018, 03:23:00 PM
I struggled getting a nice picture of the gumball design. I think I might have
to ask a friend who is pretty good with Photoshop to help me out.
Title: Re: Gumball Machine
Post by: Graham Lee on May 31, 2018, 03:24:21 PM
Hopefully one from this post or the one above can be tweaked a little.
Title: Re: Gumball Machine
Post by: Graham Lee on October 26, 2018, 10:18:39 AM
This is the gumball section of the design some 5 months later.